I want to change it to NOT have them transparent. But cannot as shown below. How do I make it an option to change?
I think you need to be in an assembly file.. then try it
John Stoltzfus wrote: I think you need to be in an assembly file.. then try it
John Stoltzfus wrote:
Nope. Mine wasn't grayed out when I opened Options from a Part file.
It wasn't grayed out in part file and opaque assembly was selected. And still grayed out in assembly file.
I was wrong on this one....turns out it is likely Large Assembly Mode:
The fact that these are also grayed out tells me that it is probably your graphics card.
Is "Use Software Open GL" checked?
I just thought of something else:
Is it possible that you are running in Large Assembly Mode?
I tested mine out by dropping the threshold to something very small and then opened an assembly.
When I open an assembly in Large Assembly Mode....I get the same thing:
So, uncheck Large Assembly mode, then close and reopen your assembly if you want to use these features.
Retrieving data ...