3 Replies Latest reply on Jul 30, 2018 4:31 PM by Bill Toft

How to make Photoview 360 view show as it does in animation.

Dominic Moore Jul 30, 2018 11:57 AM

Hi, I am trying to render a valve for a client and no matter what Resolution or aspect ratio I choose it does not view the assembly as it is shown when I run the animation in the Solidworks window. I have tried adjusting every setting I can find and nothing seems to fix it. Please help!

I have posted below 2 pictures of an example below, the view that should be shown based on my keypoint view and the actual view that is rendered.

Keypoint view:

Rendered view:

Re: How to make Photoview 360 view show as it does in animation.

Bill Toft Jul 30, 2018 3:33 PM (in response to Dominic Moore)

Can you post your assembly? Use pack-and-go.
Like Show 1 Likes(1)

Actions
- Re: How to make Photoview 360 view show as it does in animation.
  
  Dominic Moore Jul 30, 2018 4:06 PM (in response to Bill Toft)
  
  No, it is proprietary information from a client which is why I just posted a couple of pictures as an illustration. I was finally able to resolve the issue using a camera. However, without a camera the model would be partially cut off of the screen when I used Photoview 360 for rendering but it wouldn't be if I just used the standard Solidworks screen for rendering. Would you have any idea as to why that would happen?
  
  Like Show 1 Likes(1)
  
  Actions
  - Re: How to make Photoview 360 view show as it does in animation.
    
    Bill Toft Jul 30, 2018 4:31 PM (in response to Dominic Moore)
    
    I ALWAYS set up a camera (or more) before doing renderings. This way I have full control over the view(s) used.
    
    Like Show 1 Likes(1)
    
    Actions

Go to original post