Please see attached.
The Coordinate system shows up in modeling. It shows up in detailing(sorta... it likes to disappear and only re-appear after i delete the view and undo it)
It shows up in SW Print Preview.
But when I save to PDF, it disappears.
Any idea how to fix?
Thanks!
Thanks Glenn.
Adjusting the DPI from 96 to 200 allowed me to print the Coordintae system from SW->Print. Unfortunately File->Save As->PDF, still caused it to disappeared. Oh well, what's another workaround?
Another workaround I found was to insert a hole table, and use it's Coordinate system. Then just drag the actual table off of the print area, though this only gives the X/Y and not the Z. :/
Joe Haglund wrote:
Thanks Glenn.
Adjusting the DPI from 96 to 200 allowed me to print the Coordintae system from SW->Print. Unfortunately File->Save As->PDF, still caused it to disappeared. Oh well, what's another workaround?
Another workaround I found was to insert a hole table, and use it's Coordinate system. Then just drag the actual table off of the print area, though this only gives the X/Y and not the Z. :/
Did you check the DPI setting when saving to pdf? And did you try printing to pdf?
Yes and Yes. No joy
Hello everyone
I also had the same problem, the solution I used was to literally make screenshots of SolidWorks and add the image to the drawing. It worked for me. I hope it works, or they have already solved it after 2 years XD.
Cheers
Use this
file is attached
Also, while in SW Print Preview mode, If I click Next page or Previous page, the Coordinate system disappears!
I also tried printing it while it was visible in the print preview, and it did not print! What the heck!?