5 Replies Latest reply on Jul 26, 2018 10:50 PM by Mark Buchler

    From Rhino to Solidworks: Question on Proper Use of SW

    Mark Buchler

      As a few of you already know, I've been using Rhino for several years, and am now attempting to learn SW. Rhino had no specific "assembly" file option, so all components are drawn in a single file. The screenshot below shows a spray booth project drawn in Rhino, everything in one file. My question is, if I were to draw this spray booth in SW, is it more proper to create a part file for each component, and THEN drop them all into an assembly file?

       

      Thanks-

       

      exploded view.JPG