9 Replies Latest reply on Jul 20, 2018 10:49 AM by Adam Thickett

    Arc Slot with a radius edge won't allow auto centre lines

    Adam Thickett

      Hello,

       

      I have several slots cut into this panel which then have a 4mm radius on them, if I suppress the radius then I can add the auto centre lines.  Once the radius is applied and shown on the drawing it only recognises the fillet or original boss extrude as features I can dimension.

       

      Out of interest is there a way to use hole callout on an arc slot?

       

       

      This means that it only adds the centre marks to the end radius and centre individually, I have been editing these to make it look right but I thought they might be an proper solution.

       

      This is what I would like to do but

      with the radius showing

      This what happens when the radius is showing,

      I currently just shorten the middle centre line.

       

      Thanks

       

      Adam