I'm design textile cam by importing sketch from dwg. After extrude part the surface are not smooth, Please refer image.
Is there any option to get smooth surface?
Attached part are example only.
As far as I know you can't use fit spline on an edge but it was simple enough to use convert entities in a new sketch & then fit spline.
Or of course you can just edit the original sketch & use fit spline.
You can trace the edge with spline selecting points as you draw
could not work out how to convert an edge to spline,
mabye an ER
That the exact command is was looking for, never used it
Could you please guide me step by step.
Sketch on face, convert entities
highlight sketch and fit spline
hit the tick and extrude smooth cam
Thank you so much Kevin Pymm Thank You & Ned Hutchinson Thank You
Retrieving data ...