AnsweredAssumed Answered

Why doesn't the gauge table find this angle?

Question asked by Chad Huleatt on Jul 13, 2018
Latest reply on Aug 3, 2018 by Karli Kasin

Happy Saturday, forum gurus!

 

I use a gauge table to determine bend deduction. However, whenever I make a bend that is not 90 degrees (see screenshot) the gauge table fails, giving the message "The angle of this bend fell outside the bend allowance/ deduction table...". As you can see, the angle I used (135 deg) IS included in the gauge table.

 

A simple part showing failure is attached, along with my gauge table.

 

I'm using SW 2016, sp 5.0 (hoping to upgrade to 2018 soon)

 

Thanks, Chad

 

Outcomes