AnsweredAssumed Answered

Change rectangle default from popping up as "corner rectangle" to "center rectangle" in sketch?

Question asked by Dave Krum on Jul 12, 2018
Latest reply on Jul 12, 2018 by Dave Krum

Good morning All,

As the subject says, is there any way to have SW default to this?  I tend to use the "center rectangle" option 90% of the time so all the planes are based off the origin at center of my starting rectangle.  At least for me (I'm still on SW2015) it always defaults back to the corner rectangle forcing me to make an extra step to change it to "center".  I was reading on the help that it should be defaulting to the last used but not for me (I think this may have been a change to SW2016 and up only?).  Another reason for me to convince the company that I need an upgrade lol.  Thanks in advance.