This content has been marked as final.
Show 7 replies
-
Re: Isometric View Leaders Appear in wrong spots
Dan Pihlaja Jul 12, 2018 3:24 PM (in response to Trent Sauer)I have seen something similar before.
A couple of questions (none of these should matter, but they tend to):
1) Does hitting CTRL Q work?
2) Is the view resolved or lightweight?
3) How did you create the orientation? Did you create a new view at the assembly level and then pull that into the drawing, or did you just use "current view"?
-
Re: Isometric View Leaders Appear in wrong spots
Trent Sauer Jul 12, 2018 3:32 PM (in response to Dan Pihlaja)1) It rebuilds, but doesn't resolve the issue.
2) Resolved
3) I created a new view at the assembly level.
-
Re: Isometric View Leaders Appear in wrong spots
Steve Calvert Jul 12, 2018 3:42 PM (in response to Trent Sauer)This is why I always "create" a view when I'm wanting to show something in a non-standard view.
Steve C
-
Re: Isometric View Leaders Appear in wrong spots
Trent Sauer Jul 12, 2018 3:49 PM (in response to Steve Calvert)What do you mean by "create" a view?
I always click Orientation, New View.
-
Re: Isometric View Leaders Appear in wrong spots
Dan Pihlaja Jul 12, 2018 3:54 PM (in response to Trent Sauer)That is exactly what I meant....so I think you did it right.
Can you pack and go the drawing and attach it so we can look at it?
-
-
-
-
-
Re: Isometric View Leaders Appear in wrong spots
Britt Kessler Jul 12, 2018 4:55 PM (in response to Trent Sauer) -
Re: Isometric View Leaders Appear in wrong spots
ömür tokman Jul 12, 2018 4:55 PM (in response to Trent Sauer)