AnsweredAssumed Answered

Sketch dimensions showing wrong units

Question asked by Shawn Stugard on Jul 6, 2018
Latest reply on Jul 6, 2018 by Shawn Stugard

I encountered a very strange issue today. I have my units set to IPS, but my sketches show meters on the dimensions, but when I double click to change a dim, it shows inches for the input(see screenshots). I have found no way to correct it.

 

In more than 10 years of SW I've never seen anything like this. I'm using SW2014 for this particular project, one odd thing was the templates I had on hand were from a future version, so it prompted me to use a "blank" template. Certainly not a good reason for this behavior, but unusual none the less.

 

Any ideas appreciated.

Outcomes