AnsweredAssumed Answered

Can pipe Routing - give information about pipe lengths and thread types on them... ?

Question asked by Wojciech Paterski on Jul 3, 2018
Latest reply on Jul 3, 2018 by Peter De Vlieger

Hi,

We are looking into ways of getting pipe length for cutting, and we can use our current models (weldments) of pipes, but was thinking if we did our piping with Routing, if we had our fitting models (unions, sockets. etc.) configured properly, would we be able to get cutlist of pipe lengths needed and also type of thread if any is at the ends of the pipes - as an automatic SW information.

Outcomes