When working in a PART using Solidworks 2018 SP3 it seems i can only get Mass Properties to show 2 decimal points.
Is anyone else that is on this service pack experiencing this?
Ok i contacted my VAR and they helped me sort out the issue. Not really sure why it but it was the trailing zeros setting in the document properties was set to remove and changed that to show. Seems odd since i would expect that to only remove zeros but it was the issue.
No I don't have same issue
Maybe you must see the decimal places that's you got on your templates
Try changing this setting:
hmm tried this and its still the same
After you change it, you need to use this:
go to the symbol that looks like a tape measure under the evaluate tab, click it, then click in/mm, that changes your decimal places.
Retrieving data ...