I am facing problem with routing of electical cable tray design. their is no error while create and save route, error shows up while reopening the file.
i dont see any problem with route. i have attached file, please check.
It seems to forget what cable tray elbows it should be using.
Do the following, edit the 3dSketch of an offending route
and you'll see that it doesn't have a clue what sizes it should be (no base config's for either)
Selecting the location of the cable tray as well as the cable tray elbow
will result it
in both case press OK
so you get something like this
exit editing mode will give you some more 'error' boxes such as
but in the end
all is fine
and re-open and you'll get
do an edit route of an 3DSketch, don't do a thing just exit edit mode and
do a force rebuild and all is fine again, until the next time that you open
I would recommend to contact your VAR. If you do, please let us know what they found.
It was the problem with software and library installation. I tried same file on other system , after full rebuild no error was shown.
So reinstallled software and it worked fine.
Retrieving data ...