0 Replies Latest reply on Jun 23, 2018 5:42 AM by Lyubomir Ninov

    Plastic simulation high pressure at the end of packing.

    Lyubomir Ninov

      Hello.

      Whatever wall thickness i try to use and runner system even created with the runner wizard i get this high pressure at the end of packing.

      Also my runner is getting meshed pretty weird. I give it 3 degrees draft and at the bottom when i mesh im getting draft at other direction.

      If needed ill share the part and study.

      Before there was a little spot with this very high pressure but now i cant even find it.