So when i try and select a bolt in an assembly i get this logo near the cursor and i cannot select the bolt without pressing esc a bunch and clicking around it and then sometimes it works.
Oh....and specifically, that isn't necessarily a hole wizard thing (although, in this case it is)......it is specifically a cosmetic thread thing.
I just realized that you CAN do something about it.
You can turn off the view of top level (or component) annotations
And then they are not selectable. I forgot about that.
Try deselecting this option:
I have the option deselected that Glenn suggested and I still accidentally select that bloody thing all the time!
I am not sure how to NOT select it except to rotate the view a little and try again. If there is an answer, I want to know it too!
while i can't exactly have it happen on the same bolt turning it on and off, it does seem to work.. thank you so much. it was like 4:30 yesterday and i was trying to crank out this assembly and i just couldn't select the fastener. thanks.
Retrieving data ...