Hello I get a Error on Converting to sheet metal.
The curved part is not added to the Convert Solid
I tried to make this part to Base flange but then it is not merged so when I flatten it is not there.
If you must use "Convert to Sheet Metal" your main problem is with your sketch1. I fully defined it. Note especially the tangent relations.
I also changed the bend rad from what you had. Seemed a bit big. Also not sure where you wanted this broken to I did it on the end.
if i understand correctly
Hello Öür tokman, thank for you help but the design is a bit different (can you save it as version 2016)
I first do a surface extrude on the sketch
Then I want to convert it to sheet metal
But on the edges of the plane with the blue arrow I get an error
How can I add this non planar surface, the part needs to be one piece so it can be flatten
I now got this
The curved section is missing, if I add the curved section as Base Flange it is separated from the Convert solid so if i flatten it then it is not a part of it.
I am using SW 2018 only.
how will the complex closed sheet expansion be?
maybe it can be helpful..
Thanks that was it but only if I flatten now it is still missing
Before the flattening the RoundBend is in the Flat Pattern
After Flattening the Roundband is gone in the Flat Pattern file
I could not see the mistake
Retrieving data ...