AnsweredAssumed Answered

I am trying to speed up my macro function. Is there a way to hold off on displaying my commands until the process is over?

Question asked by Blake Berk on Jun 18, 2018
Latest reply on Jun 18, 2018 by Matt Camacho-Cook

I am trying to run a macro that creates a lot of points and then connects them with a spline (and declares every point coincident). When I run the file at a small number of points, it is relatively quick, but the time to run scales exponentially and I cannot get a reasonable run-time for the number of points I would like.

 

Are there any ways to speed up the process? I was thinking about trying to prevent the visuals from updating until the end, but cannot find any documentation on that.

 

Thanks.

Outcomes