Sketch ink is open and when i click on Pen nothing happen, it stays on select. Sometimes I manage to get pen selected but it will not draw, it keeps on trying to select.
What program are you working with?
Glenn, Sketch Ink is part of SW 2018.
What's New in SOLIDWORKS 2018: Touch/Pen Input for Sketching
From the same website that I linked to Glenn, it says this:
The Touch button is next to that. I’m using a stylus, but you can use this mode with your finger. Without that button pressed, swiping on my screen causes the model to move around.
I don't know ANYTHING about the touch feature.....but I thought I would mention the above, just in case it is the issue.
You need either a touch screen or a pen/tablet with Windows Ink enabled. I'm using XP-Pen Star G640. Took me a minute to figure out that I needed to check the box in the pen config to enable Windows ink. Otherwise, I was getting the same behavior as you.
I know this is old but for me the problem was to un-select "ink with touch" in solidworks. Very frustrating for a few hours to figure that out.
Retrieving data ...