AnsweredAssumed Answered

Sheet metal pipe/tube reducer?

Question asked by Kyle Taylor on Jun 6, 2018
Latest reply on Jun 6, 2018 by Kyle Taylor

Some of you may be familiar with this method of making a reducer... Is there any possible way to model that? I tried calculating out the cuts on a rolled sheet, then flattening it out to draw bend lines at the tabs but it doesn't work. I thought there was some type of option to make this. Lofted bend doesn't do the job.

I want it to look like the reducer AFTER these cuts are made.

14-08-2013-17-21-59.jpg

Outcomes