I have a drawing with the dimensions in decimal format

Am trying to change them to feet and inches

Some of them change to inches and fractions and others are still in decimal format

Any ideas?

Using SolidWorks 2018

Thanks,

Jerry

I have a drawing with the dimensions in decimal format

Am trying to change them to feet and inches

Some of them change to inches and fractions and others are still in decimal format

Any ideas?

Using SolidWorks 2018

Thanks,

Jerry

Either change the number under fractions to a larger number (I tend to go with 256) or select "Round to nearest fraction"

Example: If you have 4 in the fractions area of the picture that I have above, and you DON'T have "round to nearest fraction" selected, then any number that is not directly divisible by 1/4 does not show up as a fraction. Like 0.125. This would still show up as a decimal in this case.

Changing it to 256 however, takes most fractions into account.

I also tend to NOT check "Round to nearest fraction" because I want to know that my dimensions are exactly what I want them to be.

Were those overridden in their Property Managers?