I'm trying to cut thread profile using sweep cut following helix but it only works at certain revolutions.
It works at 1.5 revolutions but fails at 1.75 any idea how to make it work at any revolution?
You have "Align with end faces" checked.
At 1.75 revs, the end face is above the half-part face so it can't satisfy both conditions.
Uncheck it and go 1.75 revs or leave it checked and do 0.5X rev multiples.
Thank you for your help.
Craig Severn wrote: Thank you for your help.
Craig Severn wrote:
You're quite welcome.
Retrieving data ...