Since updating to 2018, SW Inspection returns 0 value when tolerance is a +0 or -0. If a value is there, it is handled correctly.
Ex 1: 2.000 +.000/-.005 returns values of Upper Limit = 0.000, Lower Limit = 1.995
Ex 2: Ø1.750 drawn and the tolerance as 'LIMIT' with +.000 and -.000 returns Upper Limit = 0.000 and Lower Limit = 1.745
I never updated to 2017, but with SW 2016 I experienced no problems with this.
Ex. 2 Shown below with for right high-lighted dimension Ø1.750/1.745:
Anybody know if there is a fix for this??