AnsweredAssumed Answered

Design table, using circular pattern, but some parts have only 1 hole

Question asked by Kerstin Bauer on May 29, 2018
Latest reply on May 30, 2018 by Peter Brinkhuis


I created a design table for simple bleed rings to control size and quantity of thread holes.

To control the quantity of the thread holes I used circular pattern, but some of the bleed rings have only 1 thread.

That causes now a problem in SolidWorks (as it is not possible to create a circular pattern with a quantity of 1). Any ideas what I can do?


Is it possible to "unselect" a hole parameter in design table when not needed?