6 Replies Latest reply on Jun 4, 2018 5:29 PM by John Stoltzfus

    BOM shows parts are ballooned when they are not

    David Williams

      I have an assembly drawing with an exploded view and a BOM. There are 5 configurations. The idea is I would like to be able to change the specified configuration of the BOM and exploded view and then auto-balloon the drawing. What I'm seeing is that auto-balloon only re-balloons parts that are not suppressed in any configuration. So, if part 1 is suppressed in configuration A but not configuration B, the BOM will show that it is ballooned when configuration B is shown but the balloon is not actually visible. You can see in the images I attached, the BOM shows that the parts are ballooned when the drawing view does not show them, and then how they should look if they were actually ballooned. Has anyone else encountered this before or have a solution?