0 Replies Latest reply on May 22, 2018 9:03 AM by Dimitra Giannopoulou

    Joints After Assembly

    Dimitra Giannopoulou

      Hi All,

       

      I have a problem. Whereas, when I am doing a static analysis to the jacket it takes into account the joints

      when I am doing a static analysis to the assembly part it doesn't consider the joints as you can see below.

      I have attached the assembly of my part in order to tell me if there is any problem. Thank you very much.

       

      Message was edited by: Dimitra Giannopoulou  I attached also the two parts of the assembly