2 Replies Latest reply on May 18, 2018 10:39 AM by Christopher Estelow

    How to change tolerance based in a rule in drawing sheet

    Shamik Chowdhury

      Hi everyone,

      I want to change the tolerance of the linear dimension of a part based on some rules.

      The rules are if the dimension is less than and equal to 400 its +1.2/0, if greater than 400 and less than or equal to 1000 then +2/0 and +3/0 otherwise.

      How can I do that automatically whenever the dimension of the component changes and also put that in the drawing sheet along with dimension.

      I have attached an image for better understanding.

      Thanks in advance.