AnsweredAssumed Answered

Sector curve in only one sweep?

Question asked by Madson Germano Silva on May 17, 2018
Latest reply on May 17, 2018 by Madson Germano Silva

I'm trying to model a sector curve to use with routing (rigid piping, not hvac)

The problem is how to meet this three conditions at the same time:

 

1) Just one file (using DT to set de configurations)

2) The number of sector varies with the angle (as below)

3) As far as I know, the main body must be made with just one sweep (routing geometry requirements)

 

Notes: The angle of each sector is 15º. I've tried circular pattern with sketch lines, but this will cause the sweep feature to fail

Outcomes