Is there a way to have the counter bore diameter change with the different "Fit" choices of close, normal and loose. Don't see anything in the database for this, just for a single size. The different fit choices, only seem to effect the thru hole.
Create a favorite or add to hole wizard yourself
I'll give this a try, thank you.
Below are CBOREs for #8 SHCS (upper is loose and lower is close).
#8 SHCS have a nominal head diameter of .270 and a .164 shank diameter.
For loose, you get 0.015 of off center radial movement.
So, adding 0.030 to the head gets you 0.300, so there's still clearance for the head.
Perhaps this is true for the head sizes of your fasteners so you may not have to create favorites as Solid Air suggested.
Thank you. I'll look farther into this.
Retrieving data ...