2 Replies Latest reply on May 14, 2018 10:09 AM by Ruben Rodolfo Balderrama

    Tapped Hole thread mark doesnt show on drawing

    Lior Kamitchi Rimon

      Hello guys,

       

      I have two tapped holes in my part, but only one of them shows the thread mark on the drawing; The one with the error...

      All the properties are equal..

      I tried to unsurpress and make a new M10 tapped hole- it didnt show too. It shows like a regular hole of diameter 8.5.

      All the settings to show annotations etc are set correctly, I checked.

       

      Any ideas how to fix this will be highly appreciated.

      the setting for both holes are: (screenshot taken from M10)

       

      Thanks!