4 Replies Latest reply on May 14, 2018 5:29 AM by Dave Bear

    Create A 3D Spline On The Centre Of A Fillet????

    Dave Bear

      Hi Folks,

      I was wondering if it is at all possible to create a 3D spline on a variable fillet and have that spline follow the mid-point of the fillet?

       

      Fillet Spline.JPG

       

      I've searched the forum but failed to find anyone ever attempting this before.

      I have attached a test part for people to play with if they desire (yep, I know it's not fully defined, it's a test part!)

      The scenario is two curved surfaces pretty much perpendicular to each other that have then been knitted together and then had a variable fillet added.

      So, as I've said, I need a 3D spine on the surface of the variable fillet that runs along the fillets curvature mid-point.

       

      How can this be done?

       

      Dave.