AnsweredAssumed Answered

DETAIL VIEW

Question asked by Jonathan O'Connor on May 10, 2018
Latest reply on May 10, 2018 by Jonathan O'Connor

I am putting together a three view drawing. It is of a mount plate that will be affixed to a single gang box. At the bottom of the mount plate is a flange that comes out at an 98 deg angle. I want to put together a detail of the flange but, because it protrudes from the plate at an angle other than 90 deg it shows hidden lines inside the detail view. I there a way for me to capture, straight on, the detail view?

Thanks!

Outcomes