3 Replies Latest reply on May 3, 2018 11:56 AM by Rubén Rodolfo Balderrama

    Revolve cut removing body instead of feature sketch

    Chad Fehr

      I usually don't start threads, but this issue has come up more than once and has me annoyed to no end.

      I have a simple washer that is two extruded diameters.  We then wanted to show a round on the top of the washer

      and a fillet (burr) on the bottom of the washer to simulate a stamping operation.  I chose to do a revolve cut (for whatever

      reason) instead of a radius feature on the top of the washer.  I drew a sketch with a radius and performed revolve cut

      to show a machined radius.  The preview shows what is to be cut, but the result is the cutting feature remained and the

      washer body was consumed.  It should be the opposite.  No matter how many times I do this, it get the same result.

      See my screen shot attached.

       

      Thanks in advance,

      Chad