AnsweredAssumed Answered

Sweep Cut on 3D sketch

Question asked by Jake Uyeda on May 2, 2018
Latest reply on May 7, 2018 by Jake Uyeda

Hey everyone,

 

So I'm not sure how to make these chamfer type edges (at 75 and 30 degrees approximately) on this housing (see pictures).

 

 

I tried a swept cut but I have an error (“sweep operation failed to complete”).  I also tried some chamfer options, but this didn't pan out either

 

 

 

This is what the part looks like overall.  Kudos to the guys for helping me out: Wrap Deboss

Let me know if you have any ideas/advice.

Thanks,

Jake

Outcomes