0 Replies Latest reply on Apr 24, 2018 5:04 PM by Jeremy Kepley

    NVS 510 vs. Quadro 2000

    Jeremy Kepley

      Just finished setting up a Dell Precision 7810 and upon opening Solidworks, I noticed that the graphics card doesn't seem to be pulling much harder than my previous computer.  My old setup had a Quadro 2000 (which was retrofitted onto an older HP) and the new card is a NVS 510.  I noticed that Solidworks doesn't specifically support this card and I'm wondering if I'd be better off just switching it out for my old card... or does anyone have any other suggestions?