When I use the wrap command this sketch gets consumed. What is reason for that?
Dave is correct.. If you delete the horizontal dims (one is an equation) and use the measure tool to get the circumference with as many decimal points as you can get and paste that value in X2 it will work.
Edit:... In other words,,, use X2 to drive the length.
You're on a newer version than me so I can't reference your model but just a couple of questions.
What are the FULL values of the diameter of your cylinder.... Your calculated circumference....... And your wrap length.......
Give me all the decimal points you can.
Same sketch but behaves in a different way. Upper part wraps but lower part does not. Even though this involves length only not depth.
Do you know the reason?
Retrieving data ...