I have a piece of formed angle (90deg bend) and I basically want to put a back bend in it at a 16" radius. Any one have suggestions? This is shown below doing it with Flex. I get an error with the flat pattern when I chose OK. I've attached the file containing the formed angle that I am trying to "roll" for lack of better terms.
Russell, look at Swept Flange in the SWX Help. I think you will see how to do exactly what you are after.
I will give that a try!
Well I tried it and I made a rolled angle, but it doesn't unfold correctly so that I can add holes.
Surely we can come up with something hahahaha
I do appreciate your response. I didn't even know about that command.
Un check flatten along path
Flatten along path is unchecked but couldn't flatten.
Swept Flanges are finicky Maha... Different breed. Doesn't like your split line at all. It does flatten correctly if you suppress the split line (and hole of course)... .
Here is one that I put some holes in between an unfold and fold. In order to make that work notice what I did at the end of the path (arc) on the profile end.
I put some holes in the folded state and it unfolds good still.
Dennis, any reason for the unfold/folds?
The reason I did that is because Russell mentioned putting the hole in the flattened (unfolded) part.
Edit:.. From what Russel mentioned I figured he planned on putting the hole in the angle prior to rolling or whatever.. Could be wrong..
Thanks for the explanation.
Thank you very much!
Thanks for the explanation.