2 Replies Latest reply on Apr 13, 2018 9:18 AM by Justin Eaton

    Balloon Asterisk Vs Item #

    Justin Eaton

      I have one drawing view that refuses to produce Item Number balloons.  There is only 1 configuration.  Top level BOM populates correctly and is attached to the drawing view, yet I still get an asterisk for each component.  All components are set to "INCLUDE" in BOM.

       

      Corrective actions:

      • Deleted sheet and recreated drawing view/BOM
      • Rebooted
      • Checked for multiple configurations (only 1 config for this assembly)
      • Checked each component for "exclude from BOM"  (all are included in BOM)

       

      Any suggestions?