I have mesh issue with part in attachment. I tried all the combinations that I know, but it still says that part can´t be meshed when it reaches 98%. Can someone please give me advice what else can I try? Thank you.
I took a look at your model. It looks like it might normally be constructed from many structural bodies that would make this easier to diagnose this STEP is one merged body instead. I used the technique here (GoEngineer - Simulation: Diagnose Single Body Mesh Failures) to diagnose the region on the model that was having trouble and it looks like the end of one of the structural members is having trouble meshing:
You may need to apply mesh controls to this region of the model or cut it off an mirror the other half over to replace it.
Retrieving data ...