I have SolidWorks 2017, SP5. I am trying to do a revolve cut as shown in the screen print on the attached model. Even though I get a preview of the cut, when I execute the cut I get the dreaded zero thickness geometry error. What am I missing?
It worked for me, if this is the cut you intended. I just found out you can use temporary axis to do a revolved cut.
It's supposed to be a cut out, mid-plane at 45 degrees rather than the whole bottom.
You are a future version so I could only guess at your sketch profile but it worked for me.
Is your axis line good?
edit: dunno if this is anything
you seem to have 4 arcs
while I have 3
Not sure if you have a vertex hiding behind that arrow
2018 Version it works fine.
What are you using for your axis?
I added a few dims to your sketch. Guessed where the axis for the cut would be which you can change.
The cut itself works, I increased the angle to 145 so it is close to the cut at the top.
Hope this helps.
Retrieving data ...