AnsweredAssumed Answered

Slots cut with assembly cut move after closing sketch.

Question asked by Jim Steinmeyer on Mar 26, 2018
Latest reply on Mar 26, 2018 by Jim Steinmeyer

One of my co-workers is seeing a strange behavior that I can not figure out. We are starting to use tabs and slots to locate some of our components. The practice has been to create the tabs in the piece parts and then create one assembly cut in the top level assembly to make sure the slots are all in the proper location. In the current assembly when he closes the the sketch the slots move away from the tabs. And apparently not consistently either. The slots are dimensioned from the tab edges creating external references so one would think they would stay where the tabs are.

Unfortunately we are on 2017 yet and I don't know how soon we will be going to 2018.


Any ideas?