Cannot trim surface
Hi, so im trying to get rid / trim this inside surfacee, but it wont seem to work, can anyone help me with this please?
Ive attached my file below.
cheers,
Luke Brient
-
Re: Cannot trim surface
Hi Luke,
I can't open your file as I'm only on SW2016 but with just looking at your image could your problem be because of this untrimmed line (open contour in the red circle)?
Dave.
-
-
Re: Cannot trim surface
I tried but it gave me many problems. If you can give me origin of this model I can start from scratch.
-
Re: Cannot trim surface
Is your Sketch1 fully defined? If not, why not?
If you do a Ctrl Q do you get any errors?
My preference would be to start over from scratch - using what was learned from this attempt.
