I have a drawing with a top level Assembly and several sub-assemblies.
1st problem is that the drawing won't allow me to promote a sub unless the assembly is opened to that configuration related to the drawing I'm working on.
The 2nd problem is that the promote does not stay. After successfully promoting the sub, saving the drawing, close and then re-open, the drawing reverts back to the old BOM (no promoted sub).
Has anyone else seen this behavior and does anyone have a fix?
Funny what happens when you ask quesrtions......
So a co worker points out to me that i need to promote the SUB ASSEMBLY in the SUB ASSEMBLY feature manager.
I was trying to promote the BOM at the drawing level.
2018 SP1