4 Replies Latest reply on Mar 20, 2018 7:53 AM by Woomy Woomy

How do I recreate this part in Solidworks?

Woomy Woomy Mar 19, 2018 6:41 AM

What I did: I offsetted a surface 0.188 units away from the surface of the extrude of the 0.6875 diameter circle. But I don't know how to ensure that the angle is 60 degrees.

Any help is appreciated!

Thank you!

2018_03_18_14_42_36_Engr_6_Take_Home_Exam_Problems.jpg 82.4 KB

Re: How do I recreate this part in Solidworks?

Dennis Dohogne Mar 19, 2018 6:53 AM (in response to Woomy Woomy)

Don't use a surface offset, use a revolved cut with the sketch profile set to the 60 degree angle.
Like Show 3 Likes(3)

Actions
Re: How do I recreate this part in Solidworks?

Aaron Torberg Mar 19, 2018 6:55 AM (in response to Woomy Woomy)

It could be made lots of ways. A chamfer, a revolved cut, or it could be part of the first feature as a revolved boss/base.
Like Show 5 Likes(5)

Actions
- Re: How do I recreate this part in Solidworks?
  
  Aaron Torberg Mar 19, 2018 7:00 AM (in response to Aaron Torberg)
  
  Like Show 5 Likes(5)
  
  Actions
- Re: How do I recreate this part in Solidworks?
  
  Woomy Woomy Mar 20, 2018 7:53 AM (in response to Aaron Torberg)
  
  Thank you!
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post