4 Replies Latest reply on Mar 15, 2018 3:52 AM by Mark Greenwell

    Lay out points

    Mark Greenwell

      Hi,

       

      I have a drawing showing the positions to the corners of the plates from a reference line.

       

      It look a bit cluttered so I was thinking is it possible to somehow create a reference point at these corner positions and then create a list showing these positions from a designated reference position (example the centre of the plate). Similar to how to how the hole table feature works, where you get X, Y dimensions for each hole position.

       

       

      Thanks

       

      Mark (SolidWorks 2018 sp2)