AnsweredAssumed Answered

Cutting ribs on a nozzle

Question asked by Jake Uyeda on Mar 13, 2018
Latest reply on Mar 13, 2018 by Mahir Abrahim

Hey everyone,

 

So I'm trying to get the ribings on this nozzle section to look like this:

 

I'm having trouble getting the ribs in solidworks to look angled in.  As you can see, I clumsily tried doing this with a 3d surface loft, then cut extruding, but this doesn't cut along the contour of the nozzle.    Note: The ribs were made with Boss-Extrude6 and CirPattern1.

 

 

 

As a bonus, if you know how to get rid of the ribs on the inside of the nozzle that would be great too.  I tried surface offset and surface cut to no avail. 

 

Any help you can give would be appreciated.  The SW file is attached.  Thank you!

Outcomes