Surface Sweep is not coming. What is the reason?
It swept the profile surface, but it didn't show it - seemed to work fine as soon as I decreased the number of turns & changed the pitch.
I started playing around with the number of turns and pitch after the swept surface appeared.
This is 11mm pitch with 10 turns.
Thanks for your explanation.
My guess is that SW doesn't know what to do with the end of the line that is not attached to the curve. If you are trying to make a helical swept surface you can define the sweep path as a vertical line and use the twist attribute to determine the number of revolutions.
I found that if Revolutions are in decimal it will not work.
Retrieving data ...