AnsweredAssumed Answered

Swept Boss and Indent

Question asked by Jake Uyeda on Mar 6, 2018

Hi everyone, I could use some help getting these "veins" indented into the bottom of this part.  (*NOTE: SW2017 file is attached)

 

I was able to get one vein in place, but it was complicated because I had to make a sketch plane offset from the edge for the swept boss (see picture below). 

 

 

So I'm not sure how to make the sweep's end face aligned with this face (note that there is an offset so I can't check "align with end faces" for it to work)

 

 

 

I can't have this cut on the bottom side of the part.

 

Any advice or help you could give would be much appreciated!

Attachments

Outcomes