Hi,
I am trying to finish the thumb rest with Loft feature, but I am not able to select the point at top to close the Loft, like it is showing in Solidprofessor. I have attached the model and a picture here.
Any suggestions would be appreciated!
Thank you!
Miranda
That model looks familiar for some reason...
It works. I had to select the point from the FeatureManager. You may also have to manipulate the handle to get it to go, and set the end constraints properly. A lot of things have to be in place for these things to work. The point tangency has to be set to Normal To Profile.
Thank you so much Matt!
I clicked around and finally made it work! Also followed your suggestions on the start and end constraints.
Thanks again!
That model looks familiar for some reason...
It works. I had to select the point from the FeatureManager. You may also have to manipulate the handle to get it to go, and set the end constraints properly. A lot of things have to be in place for these things to work. The point tangency has to be set to Normal To Profile.