2 Replies Latest reply on Feb 11, 2009 3:13 AM by Ameer Chilakala

CosmosExpress error:"No solid body to process"

Devon Berman Feb 9, 2009 12:58 PM

When I try to run my part in CosmosExpress, I get an error "No solid body to process". I can't post the part unfortunately. The part shows up as a solid body in the feature tree. I'm hoping someone else has seen this problem and fixed it without remodeling the whole part.

CosmosExpress error:"No solid body to process

Christopher Thompson Feb 9, 2009 2:02 PM (in response to Devon Berman)

I have not used ComosXpress, but use CosmosWorks Designer (static FEA) as part of my SolidWorks Office Premium license.

Have you assigned material properties to the part, and have you created a mesh before running the analysis?
Like Show 0 Likes(0)

Actions
- CosmosExpress error:"No solid body to process
  
  Ameer Chilakala Feb 11, 2009 3:13 AM (in response to Christopher Thompson)
  
  While using Solidworks simulationXpress, it will not support multiple solidbodies with in a part. Try to suppress sharp fillets etc. If possible save the part, then use simulaitonXpess, while using simulaitonXpress unselect the Solidworks Simulation form the Add-inn options if you are having Solidworks Simulation product.
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post