How do i get rid of these lines i need one of these plus signs to be a minus
I need the sketch to be wrapped on to the key but I cant delete and fill the face?
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
Free bump to the top Miranda ...
I tried to help as I love these ones but your in a "Future Version" as I'm only on SW2017 ...
I guess the only thing I can add without being able to open the file would be to find the sketch that controls the "Wrap" and edit one of the Plus Signs to a Minus Sign in there ...
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
That is saved in a different file. I had to save an assembly as a part because I needed a surface from another part to complete what I needed todo. I tried to delete and fill it didn't work. So I tried filling surface on curvature but it wouldn't make it solid. I'm stuck I cant think of any other ways to get rid of the scribed plus and I would prefer not starting over of course. I could try to attach an IGS?
-
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
...Delete Face (Patch) the + faces. (images attached)
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
I have tried that I get rebuild errors saying is has failed due to geometry condition.
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
I was able to use that in the IGS but not in my part file. Which is fine I still have the same outcome but now I cant go back to make changes and I don't understand why I couldn't patch it in the part file.
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
Miranda,.. before deleting the faces.. run a Tools/Geometry Analysis and see if there are errors (and repair them).
Also, check to see if you have VOR On (Tools/Options/System Options/Verification on rebuild)
-
-
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
Miranda,,, perhaps I'm not understanding the question correctly but this is how your file opens for me.
I also don't understand why you (or I) can't delete and patch in the original part file. However I did find that with a delete face, offset (0) and a couple of delete holes then knit to solid I could get rid of the plus and minus and,,, keep the rest of the features.
-
Re: How do i get rid of these lines i need one of these plus signs to be a minus
Yeah I have gotten the gray of death but changed out my memory to fix it. I just never understand why soildworks will work and then other times it wont when if I make it an IGS it will work.
-
